Difference between revisions of "Template:Tenderloin Install Steps"

From WebOS-Ports
Jump to: navigation, search
Line 13: Line 13:
 
3. Download the kernel and add it to the boot partition as uImage.LuneOS and either symlink it to uImage or use moboot. Follow the instruction below:
 
3. Download the kernel and add it to the boot partition as uImage.LuneOS and either symlink it to uImage or use moboot. Follow the instruction below:
  
- Boot into webOS
+
- Boot into webOS (make sure to have Developer Mode enabled!)
  
 
- Run novaterm
 
- Run novaterm
  
 
<code>
 
<code>
- mount -o remount,rw /boot
+
mount -o remount,rw /boot
  
 
cd /boot
 
cd /boot

Revision as of 21:19, 7 July 2014

Preparing your device & installation instructions

1. Create an ext3fs lvm partition of at least 1GB (use Tailor or Meta-Doctor to achieve this). It must be named ext3fs ! Tailor automatically uses this name for an ext3 partition.

2. Download the image, copy it to the USB driver (/media/internal) and extract it into the new partition by issuing the following commands:

mkdir /media/ext3fs && mount /dev/store/ext3fs /media/ext3fs

cd /media/internal

tar xzf webos-ports-dev-image-tenderloin.tar.gz -C /media/ext3fs

3. Download the kernel and add it to the boot partition as uImage.LuneOS and either symlink it to uImage or use moboot. Follow the instruction below:

- Boot into webOS (make sure to have Developer Mode enabled!)

- Run novaterm

mount -o remount,rw /boot

cd /boot

rm uImage

exit

novaterm put file://boot/uImage < moboot.uImage

novaterm

cd /boot

ln -sf uImage-2.6.35-palm-tenderloin uImage.webOS

Output should look like: Moboot.png